Cloud Care Networks
Panorama C240SP-10SMAJ-5GA SMA Male to SMA Female 10 m CS240 Coax Cable (5GA Label)
Panorama

Panorama C240SP-10SMAJ-5GA SMA Male to SMA Female 10 m CS240 Coax Cable (5GA Label)

MPN: C240SP-10SMAJ-5GA5G
$56.43$78.17Save $21.74

Backordered — ships when available

1
Secure checkout

Key Features

  • Connect SMA male-terminated equipment to SMA female ports in one tested, ready-made 10 m run
  • Skip field crimping - both connectors are fitted and checked at the factory
  • Preserve signal over long runs with ultra-low-loss 6.1 mm CS240 double-screened coax
  • Route the flexible 6.1 mm cable through tight dashboard, cabinet, and tray paths without kinking
  • Match this run to antenna element A instantly using the factory 5GA label - no tracing cables at hookup
  • Meet in-building safety expectations with the flame-retardant, zero-halogen jacket

Technical Specifications

Package

BrandPanorama Antennas
Product TypeCoaxial antenna cable assembly
Manufacturer Part NumberC240SP-10SMAJ-5GA

Physical

Jacket TypeFlame-retardant zero-halogen (FRZH)
Cable Length10 m (32.8 ft)
Cable Diameter6.1 mm (0.24 in)
Identification5GA port-identification label

Compliance

Halogen FreeYes
Flame RetardantYes (FRZH jacket)

Connectivity

Impedance50 ohms
ShieldingDouble shielded
Cable SeriesPanorama CS240
Connector End ASMA male
Connector End BSMA female

About This Device

The Panorama C240SP-10SMAJ-5GA is a 10 m (32.8 ft) CS240 coaxial cable assembly terminated with an SMA male connector on one end and an SMA female on the other. CS240 is Panorama's ultra-low-loss 6.1 mm double-screened coaxial cable, built for longer runs where thinner coax would give up too much signal before it reaches the radio. A flame-retardant, zero-halogen (FRZH) jacket adds a margin of safety for in-building runs where cable fire behavior is regulated. The SMA male end threads onto the SMA female antenna ports found on most cellular routers and gateways, including Cradlepoint, Teltonika, Digi, Peplink, and Sierra Wireless hardware. The SMA female (jack) end accepts any standard SMA male antenna or jumper, which makes this assembly a straight in-line extension for an existing antenna run. This variant carries a factory-fitted "5GA" identification label, matching the port markings on Panorama's multi-element 5G antennas. When you pull four identical runs to a 4x4 MIMO antenna, the 5GA label ties this cable to antenna element A at both ends of the run, which removes the guesswork at hookup time. As with any coax, plan the shortest run that reaches: extra length adds loss you cannot get back. Route the cable away from high-current wiring where practical, avoid tight kinks at the connector boots, and leave a small service loop at the equipment end. Panorama Antennas has designed and manufactured antenna systems and RF cable assemblies since 1947, and every CS240 assembly ships with its connectors fitted and tested before it leaves the factory - eliminating the most common failure point in field-built coax.