Panorama C29FP-5F 5m CS29 Coax Cable, FME Male to FME Female

When an antenna cannot sit next to the equipment it feeds, the cable in between decides how much signal actually arrives. The Panorama C29FP-5F covers that gap with 5 m (16.4 ft) of CS29 low-loss coax, factory-terminated with a compact FME male plug and a compact FME female jack. Panorama's CS29 cable is double-screened 5 mm coax with a stranded centre conductor and semi-air-spaced dielectric, running at the 50-ohm impedance used across cellular, GNSS and Wi-Fi RF paths. The stranded centre conductor keeps the cable flexible for tight routing, while the double screen holds attenuation low across cellular, GNSS and ISM frequencies. Because both connectors are terminated and tested at the factory, you avoid the loss and reliability penalties of field crimping. On the equipment side, the FME jack mates with FME male terminations, and it adapts to SMA, TNC or N-type via low-cost FME adapters. At the other end, the FME plug connects to FME female cable ends and antenna tails; the small FME head is designed to pull through tight grommets and panel holes first, then terminate or adapt as needed. Typical uses include extending roof or wall-mounted antenna feeds to a rack-mounted cellular router and repositioning a paddle or dome antenna away from RF-noisy equipment. Route the cable with gentle bends, avoid crushing it under cable ties, and snug threaded connectors evenly to keep the RF joint consistent. For IT teams and installers, a pre-terminated Panorama assembly is the fast path to a clean, repeatable install: pick the length, match the connectors, and skip the crimp tooling entirely.