Panorama C32SP-3SMARV-WIFI1 3 m CS32 Coax Cable, SMA Male to RP-SMA Male, Wi-Fi Label 1

The Panorama C32SP-3SMARV-WIFI1 puts 3 m (9.8 ft) of low-loss CS32 coax between your equipment and your antenna. It is the piece that separates antenna placement from equipment placement, which is usually the difference between marginal and solid Wi-Fi. CS32 is Panorama's double-shielded, solid-core 5 mm coaxial cable: a 50-ohm design intended for antenna feed runs where attenuation and interference rejection both matter. The dual shield keeps noise from adjacent power and data cabling out of the feed, and the solid core holds loss well below the thin RG174-class pigtails bundled with many antennas. One end is factory-terminated in a SMA male (plug), the other in a RP-SMA male. The SMA male end threads directly onto the SMA female antenna ports found on most cellular routers, gateways, and modems. Reverse-polarity SMA is the interface most Wi-Fi equipment uses, so confirm whether your gear is standard or reverse-polarity before ordering. At 3 m, the run reaches across a room or up through a ceiling void. The 5 mm jacket stays flexible enough for conduit, cable glands, and grommet routing, and factory-molded terminations remove the most common failure point of field-crimped coax. This is the Wi-Fi 1 label unit: every cable in the set is electrically identical, and the tag simply identifies which antenna port a run belongs to once several cables disappear into the same wall or roof gland - commissioning and later troubleshooting become a label check instead of guesswork. Cloud Care Networks carries the C32SP-3SMARV-WIFI1 alongside the antennas and cellular routers it connects, so network and field-service teams can consolidate feed lines, spares, and hardware on one order. Keeping a spare assembly on the truck turns a damaged run into a five-minute swap instead of a site revisit.